Daytime running lamps (DRL) (if equipped)
To activate:
• the ignition must be in the on position,
• the headlamp control must be in the off, autolamps or parking lamp
position and
• the transmission must be out of the P (Park) position.
WARNING: Always remember to turn on your headlamps at dusk or during inclement weather. The Daytime Running Lamp (DRL) system does not activate the tail lamps and generally may not provide adequate lighting during these conditions. Failure to activate your headlamps under these conditions may result in a collision.
See also:
Starting your vehicle
This system meets all Canadian interference-causing equipment standard
requirements regulating the impulse electrical field strength of radio
noise.
Don’t press the accelerator before or during ...
Increasing speed while using speed control
To set a higher speed:
• Press and hold SET + until you get to the desired speed, then release.
You can also use SET + to operate the tap-up function. Press and
release SET + to increase the v ...
Sounding a panic alarm
Press to activate the alarm.
Press again or turn the ignition to on to
deactivate.
Note: The panic alarm will only operate when the ignition is off. ...